- -15%
DESCRIPTION
The tubeless valve system patented by MILKIT is fast and easy to use:
Intelligent rubber flaps ensure that you do not lose air when removing the valve core and that the sealer does not block the valves.
Use the syringe to easily control if it remains enough sealing in your tyre.
The syringe accurately measures the amount of necessary sealing
Tires can be installed dry and the sealant can be added later through the valve.
The kit contains the measuring and filling syringe, valves and valve core removal tool.
This patented system allows a clean and easy assembly of tubeless tires.
The solution to fight drying or leaking the sealant! With other tubeless tyre valve systems you need to remove the tire to check if it remains enough sealing, with MILKIT you can simply remove the valve core and insert the syringe to control. No disorder and faster results!
The syringe contains 60 ml or 2 ounces of fluid and comes with a flexible connector and a large needle to push through the valve and rubber fins. There is also a sealing regulator that screws into the syringe for easy charging. The needle has an angled end for effective removal of the whole sealant in the tire.
The patented MILKIT lends bike valves are made in Germany of high quality anodized aluminum alloy and high performance rubber for smart fins.
The MILKIT standard valves have a usable length of 35 mm (1 3/8 inch), and work for most road and mountain bike wheels, except for some special high-profile wheels.
MILKIT valves can be used with most sealants, but we recommend the milKit sealer. This is specially designed to achieve the best results with these valves.
MODE OF USE
Install the valve and unscrew the core of the MILKIT valve.
Pre-flame your tire up to 22 psi: rubber flaps ensure that air is not lost even with the valve core removed.
For maintenance rather than installing a new tyre: extract the old sealant from the tire with milKit syringe to measure the remaining amount and control the quality.
Measure the correct amount of sealant and inject with the syringe.
Reboot the valve core, inflate the tire at maximum pressure until the tire completely jumps on the rim and you are ready to drive!
CONTENT
2x 35 mm MILKIT valves
1x measuring and filling syringe
1x valve carriage tool
2x stickers for MILKIT circles